Setting the Date and Time in Linux

You have at least 2 methods for setting the date and time in Linux:

  1. You can set the time by hand, but be careful, lots of clocks tend to drift over time. The trick here to make the time stick across a reboot is to run the hwclock command as shown below
  2. You can use NTP (Network Time Protocol) to get accurate time from a network time server (Atomic Clock). I highly recommend using NTP to keep your time set correctly: ntp.html

Note: Just using the date command alone will not cause the date to remain after a reboot. The date command sets the Linux system clock which is separate from the hardware clock. The “hwclock –utc –systohc” command is used to update the hardware clock with the date from the Linux system clock.

Run the date command to make sure you have the correct time:

[[email protected] /root]# date
Thu Sep 20 11:00:06 CDT 2001
[[email protected] /root]# 

If you have the wrong timezone set, use “timeconfig” or “linuxconf” to set the correct timezone.

If your timezone is correct but the date and/or time needs updating, the following commands will update the date and time. The second command is needed in order to push the date and time into the PC clock.

[[email protected] /root]# date 092011082001
Thu Sep 20 11:08:00 CDT 2001
[[email protected] /root]# hwclock --utc --systohc
[[email protected] /root]# 

Leave a Comment